OnePlus 2 Teardown
OnePlus 2 Teardown and Reassemble Guide
Find affordable OnePlus 2 replacement screens and parts here.
Power down your OnePlus 2 smartphone.
Use the plastic triangle opening tool, or your fingernails, to work around the rear cover and release the plastic clips securing it in place.
Remove the dual-slotted Nano SIM tray- no SIM ejection tool needed!
With the fine-tip curved tweezers remove the 6 black rubber screw covers and the 1 white tamper evident seal.
Remove the following 18 Phillips screws securing the midframe cover in place.
Use the iSesamo opening tool to assist in removing the midframe cover from the OnePlus 2 smartphone.
With the fine-tip curved tweezers remove the piece of black tape covering the battery connector, and then with the nylon spudger disconnect the battery from the motherboard.
Use the iSesamo opening tool, or the triangle opening tool, to carefully pry up the 3.8 V, 3,300 mAh OnePlus 2 battery that is held in place with small amount of adhesive.
With the nylon spudger, disconnect the rear-facing camera from the motherboard.
Remove the 13 MP OnePlus 2 rear-facing camera.
With the nylon spudger, disconnect the front-facing camera from the motherboard.
Remove the 5 MP OnePlus 2 front-facing selfie camera.
Remove the following Phillips screw that helps secure the OnePlus 2 motherboard in place.
With the fine-tip curved tweezers remove the small piece of black tape, and make sure the alert slider located on the side of the smartphone is pushed up.
Use the nylon spudger to detach the handful of cables still keeping the motherboard in place.
With the screw removed, alert slider up, and the cables detached, use the spudger to pry up the motherboard.
Use the nylon spudger to disconnect the OnePlus 2 USB-C port from the daughterboard and carefully lift up the ribbon cable.
Now utilize the fine-tip curved tweezers to assist in removing the USB-C port from the midframe.
With the nylon spudger disconnect the following 2 ribbon cables from the daughterboard.
Carefully pry up the OnePlus 2 daughterboard and remove it from the midframe.
Remove the earpiece speaker utilizing the iSesamo opening tool.
Use the heat gun to soften the adhesive securing the display assembly to the midframe. You will need to continuously reapply heat during this step.
With the nylon spudger, through the front-facing camera hole, push the display assembly away from the midframe to create separation.
Now with a couple of triangle opening tools, and plenty of heat, work around the OnePlus 2 LCD and Touch Screen Assembly and free it from the midframe.
Use the nylon spudger to carefully remove the delicate side button cables from the the back of the OnePlus 2 display assembly.
With the nylon spudger pry up the OnePlus 2’s soft home button that features a fingerprint sensor.
* To reassemble your device, follow the steps in reverse order.