iPhone 7 Plus Rear-Facing Camera Repair

iPhone 7 Plus Rear-Facing Camera Repair Guide

Find brand new iPhone 7 Plus repair parts here.

Recommended Tools: 

Plastic Triangle Opening Tool
Nylon Spudger
SIM Card Ejection Tool
Fine Tip Curved Tweezers
Precision Knife Set
Phillips Screwdriver
Pentalobe Screwdriver
Tri-Point Screwdriver

Step 1

Power down your Apple iPhone 7 Plus smartphone.
 
Step 2
 
Eject the Nano-SIM Card Tray.
 
Step 3 (iPhone 7 Plus Display Assembly)
 
Remove the two bottom 3.4 mm Pentalobe screws located next to the lightning connector.
 
Step 4
 
Use the precision knife to create enough space to insert a triangle opening tool.
 
With the opening tool slice through the intense adhesive and help carefully decouple the iPhone 7 Plus display assembly from the rear case.
 
Unlike previous iPhone models the 7 Plus bizarrely opens to the side.
 
The display assembly is still connected to the iPhone by cables along the middle-right side, so don’t try to remove it entirely just yet.
 
Remove the following 4 Tri-Point screws securing the bracket that covers the battery connector and two of the display cables. These screws are different sizes, so be sure to remember where they go.
 
With the bracket out of the way spudge up the cables from the logic board.
 
Remove the following 3 Tri-Point screws that secure the bracket covering the upper component display cable.
 
Disconnect the cable and free the iPhone 7 Plus display assembly from the phone.
 
Step 5 (iPhone 7 Plus 12 MP Rear-Facing Cameras)
 
Remove the following Phillips screw and standoff screw.
 
Remove the protective metal cover.
 
With the spudger in hand, disconnect the two 12-megapixel iPhone 7 Plus rear-facing cameras and pry them out of the chassis. One camera is wide-angle with optical image stabilization, the second allows for optical zoom.
 
 
* To reassemble your device, follow the steps in reverse order.

 

You can save time by selecting any number of products from this page and then add them all to the cart with just one click.