iPhone 6s Plus Battery Repair

iPhone 6s Plus Battery Repair Guide

Find high quality, affordable iPhone 6s Plus replacement screens and parts here.

Recommended Tools: 

Small Phillips Screwdriver
iPhone 5-Point Pentalobe Screwdriver
iSesamo Opening Tool
Suction Cup
Fine Tip Curved Tweezers
Battery Adhesive Strips

Step 1

Power down your iPhone 6s Plus.
 
Step 2
 
Remove the two bottom 3.4 mm Pentalobe screws located next to the lightning connector.
 
Step 3
 
Place a suction cup near the home button and pull the iPhone 6s Plus display assembly away from the rear case. Use the iSesamo opening tool to slice through the adhesive and help carefully separate the display assembly from the rear case.
 
Take your time and apply firm, constant force. The display assembly is a much tighter fit than most devices and is held down with adhesive.
 
Do not open the iPhone's display assembly more than 90 degrees, as it is still connected at the top by three ribbon cables that may break if stretched.
 
Step 4
 
Remove the following 5 Phillips screws securing the metal cover to the 6s Plus motherboard.
 
Now use the fine tip curved tweezers to disconnect the LCD, digitizer and front camera and proximity sensor cables.
 
Step 5
 
Remove the following 2 Phillips screws securing the metal battery connector bracket to the motherboard.
 
Now, use the fine tip curved tweezers to remove the metal battery connector bracket and then disconnect the battery connector from the motherboard.
 
Step 6
 
Use the fine tip curved tweezers to peel up the edges of the three adhesive strips at the bottom of the 6s Plus battery.
 
Grab the end of the first adhesive strip and try to keep the strip flat and wide.
 
Slowly and gently pull each strip up and away from the iPhone. The strips will stretch to many times the length of the battery- keep pulling until they come out from between the battery and the rear case.
 
Now, remove the iPhone 6s Plus battery from the rear case.


* To reassemble your device, follow the steps in reverse order.