iPhone 6 Display Assembly Repair
- You are performing this repair at your own risk
- We claim no responsibility for any damages that might occur
To perform this DIY repair, you will need:
- Plastic Triangle Opening Tool (Item # 5-0007)
- Suction Cup (Item # 5-0020)
- Fine Tip Curved Tweezers (Item # 5-1370)
- Professional Phillips Screwdriver (Item # 5-2432)
- Professional iPhone Pentalobe Screwdriver (Item # 5-2433)
CHECK OUT THE VIDEO HERE!
Power down your iPhone 6.
Remove the two bottom 3.4 mm Pentalobe screws located next to the lightning connector.
Place a suction cup near the home button.
While applying firm, constant force, use the plastic triangle opening tool to work around the display assembly and separate it from the iPhone 6 rear case.
The display assembly is still connected to the iPhone by several cables, so don’t try to remove it entirely just yet.
Remove the following 5 Phillips screws securing the metal bracket to the motherboard.
Now use the fine tip curved tweezers to remove the metal bracket and disconnect the LCD, digitizer and front camera and proximity sensor cables.
Remove the following 3 Phillips screws securing the earpiece speaker bracket to the display assembly.
With the tweezers remove the bracket and then the earpiece speaker.
Gently pry the front camera and proximity sensor ribbon cable away from the display assembly.
Remove the following 2 Phillips screws securing the home button metal bracket in place.
Disconnect and peel the home button ribbon cable away from the display assembly.
Remove the home button assembly.
Remove the 7 Phillips screws that secure the LCD shield plate to the display assembly.
Peel up the adhesive securing the home button cable connector to the front panel and remove the LCD shield plate.
All of the replacement parts and repair tools used in this video are available at www.fixez.com. Make sure to take a look at our other DIY smartphone and tablet repair tutorials.